Wifi Issue with P4

[EgaReef]

Hi,

I have the same problem with IP of Auto.

https://youtu.be/vPSiKLujGcI

[decena]

These are my communication settings:

1.jpg

I pinged it:

2.jpg

I set up a new P4 connection using ip:

3.jpg

And tried to connect:

4.jpg

I tried both methods (static and dynamic). But it doesn't work. I cannot connect to GHL control center by Wifi. But...... I can connect to MYGHL. ¿What happens? This is very strange:

5.jpg

[decena]

I can connect to MYGHL and modify everything. But I cannot connect to GHL Control Center using Wifi:

6.jpg
7.jpg

[Matthias]

Hi,

I have the same problem with IP of Auto.

https://youtu.be/vPSiKLujGcI

please use NOT Auto and enter the static IP

if your P4 is accessible under a certain IP x.x.x.x and you ping this IP successfully GG MUST connect to this IP when you have this IP in the connection settings, there is no way it doesn't work

[Matthias]

Decena, why client AND access point?

- use client mode only
- enter the static IP (NO DHCP) and the correct subnet, gateway and DNS

save
disconnect
just to be sure reoboot P4

[EgaReef]

please use NOT Auto and enter the static IP

if your P4 is accessible under a certain IP x.x.x.x and you ping this IP successfully GG MUST connect to this IP when you have this IP in the connection settings, there is no way it doesn't work

I don't used Auto, I have static IP 192.168.2.200

You can see it in the video.


Enviado desde mi Nexus 5 mediante Tapatalk

[decena]

Decena, why client AND access point?

- use client mode only
- enter the static IP (NO DHCP) and the correct subnet, gateway and DNS

save
disconnect
just to be sure reoboot P4

Hi Matthias, I have just try with your setting, but I get the same error: "Could not connect. ¿Do you want to check the settings now?". These are my new settings:

Captura de pantalla 2017-04-29 a las 11.01.16.jpg

Captura de pantalla 2017-04-29 a las 11.01.32.jpg

[Yosh01]

Try to do the following trick that helped me:

0. Connect cia GCC/ USB to the PL4
1. Go to communication and click WPS Setup
2. Wait a few seconds then disconnect
3. Connect again
4. Go to communication and deactivate WiFi and save
5. Disconnect again an wait until the WiFi LED is off
6. Connect again and activate client mode (Settings are not lost)
7. Save, disconnect, wait until green wifi led comes on again, try to connect via wifi

This works for me.

[decena]

Try to do the following trick that helped me:

0. Connect cia GCC/ USB to the PL4
1. Go to communication and click WPS Setup
2. Wait a few seconds then disconnect
3. Connect again
4. Go to communication and deactivate WiFi and save
5. Disconnect again an wait until the WiFi LED is off
6. Connect again and activate client mode (Settings are not lost)
7. Save, disconnect, wait until green wifi led comes on again, try to connect via wifi

This works for me.

Thanks a lot Yosh01. Now, it works perfect. Thanks !!!

[EgaReef]

Hi,

I have already successfully connected via Wifi. I have updated both the Profilux and the Wi-Fi to the latest version.

But I still use the emergency update.

Regards