Hi,
I have the same problem with IP of Auto.
https://youtu.be/vPSiKLujGcI
Hi,
I have the same problem with IP of Auto.
https://youtu.be/vPSiKLujGcI
These are my communication settings:
1.jpg
I pinged it:
2.jpg
I set up a new P4 connection using ip:
3.jpg
And tried to connect:
4.jpg
I tried both methods (static and dynamic). But it doesn't work. I cannot connect to GHL control center by Wifi. But...... I can connect to MYGHL. ¿What happens? This is very strange:
5.jpg
Last edited by decena; 28.04.2017 at 17:51. Reason: Correction
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Decena, why client AND access point?
- use client mode only
- enter the static IP (NO DHCP) and the correct subnet, gateway and DNS
save
disconnect
just to be sure reoboot P4
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Hi Matthias, I have just try with your setting, but I get the same error: "Could not connect. ¿Do you want to check the settings now?". These are my new settings:
Captura de pantalla 2017-04-29 a las 11.01.16.jpg
Captura de pantalla 2017-04-29 a las 11.01.32.jpg
Try to do the following trick that helped me:
0. Connect cia GCC/ USB to the PL4
1. Go to communication and click WPS Setup
2. Wait a few seconds then disconnect
3. Connect again
4. Go to communication and deactivate WiFi and save
5. Disconnect again an wait until the WiFi LED is off
6. Connect again and activate client mode (Settings are not lost)
7. Save, disconnect, wait until green wifi led comes on again, try to connect via wifi
This works for me.
Hi,
I have already successfully connected via Wifi. I have updated both the Profilux and the Wi-Fi to the latest version.
But I still use the emergency update.
Regards
Bookmarks