Zeige Ergebnis 1 bis 6 von 6

Thema: Backup Profilux 3 settings and transmit to Profilux 4?

  1. #1
    Registriert seit
    01.06.2013
    Beiträge
    14

    Standard Backup Profilux 3 settings and transmit to Profilux 4?

    Hi everyone,

    I have just received my new Profilux 4 in the mail and want to know if I can simply backup my profilux 3 configuration and settings and then transmit them to the new profilux 4?

    When I go into the GCC when connected to the Profilux 4 the ability to transmit files to the profilux is greyed out?

    profilux.jpg

    Any help would be appreciated... I really don't want to have to set everything up again!

    Jamie

  2. #2
    Registriert seit
    06.02.2012
    Beiträge
    2.020

    Standard

    if I can simply backup my profilux 3 configuration and settings and then transmit them to the new profilux 4?
    Due the different internal structure that´s not possible. You have to input your settings by hand.


    When I go into the GCC when connected to the Profilux 4 the ability to transmit files to the profilux is greyed out?
    It´s added later.

  3. #3
    Registriert seit
    01.06.2013
    Beiträge
    14

    Standard

    Thankyou... looks like a lot of programming ahead for me.

    I'll assign the PABs (I have 18 sockets), then hook the P3 back up to keep on chugging whilst I finish the set up of all the level sensors, Tunze pumps etc on the P4.

  4. #4
    Registriert seit
    01.12.2011
    Beiträge
    31

    Standard

    Though official reply that transfer of P3 data does not work. I find some data is still successfully transefered.

  5. #5
    Registriert seit
    18.02.2009
    Ort
    Kaiserslautern
    Beiträge
    7.644

    Standard

    Zitat Zitat von palmlover Beitrag anzeigen
    Though official reply that transfer of P3 data does not work. I find some data is still successfully transefered.

    NEVER do this - the P4 data may get corrupted!

    I must add a mechanism in GCC which blocks this!
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  6. #6
    Registriert seit
    01.12.2011
    Beiträge
    31

    Standard

    Dear Mathias

    If so, please make it forbidden in GCC and should make clear statement in manual. (I do not find any warming in manual nor GCC. LUCKILY, I DO.not. have any problem.)

Forumregeln

  • Es ist dir nicht erlaubt, neue Themen zu verfassen.
  • Es ist dir nicht erlaubt, auf Beiträge zu antworten.
  • Es ist dir nicht erlaubt, Anhänge hochzuladen.
  • Es ist dir nicht erlaubt, deine Beiträge zu bearbeiten.
  •