Hallo. I have just received my Profilux 4 and it works very well :-) I have just successfully added 2 x Tunze 6055 that run on group 1 and a Tunze nano wavebox that run on group 2. The wavebox are programmed to sequence 1 and Right angled waves with minimum and max wave duration of 0,9 s. The pump power are set at minimum at 0 % and maximum at 100 %.

Can this damaged the socket of the profilux ?? In the programming manual on page 37 it says :

"If a switching socket is to control the corresponding flow pump, the time period must not be too small - otherwise too frequent switching can lead to damage to the socket or the pump!"

Or is this a problem if the profilux are switching with 2 different pump groups too frequent ??


Best regards
Kasper Jensen