Hi all
Am I doing something wrong while upgrading firmware on PL3EX to 6.29?
Im using GCC 1.0.9.2 as 4 somehow it doesnt pass the powerbar switch part and comes with following message...??
Happens on 2 individual pl3ex ?
Hi all
Am I doing something wrong while upgrading firmware on PL3EX to 6.29?
Im using GCC 1.0.9.2 as 4 somehow it doesnt pass the powerbar switch part and comes with following message...??
Happens on 2 individual pl3ex ?
Okay i think it was related to laptop i was using.. I reinstalled all drivers and after reboot both PL3 upgraded successfully...
Bookmarks