IMPORTANT: ProfiLux 4 and DCF receiver
Unfortunately it turned out that connecting a DCF module (radio controlled clock) on the ProfiLux 4 can cause problems and affect the new internal clock of the ProfiLux 4.
In the worst case it can happen that ProfiLux 4 can't be rebooted anymore, even after unplugging the DCF module.
This issue will be fixed with the new firmware 7.03, included in the new GHL Control Center 1.0.9.3, availabe from 13. Feb. 2017 on.
IMPORTANT: Don't use the DCF module as long as the ProfiLux 4 still has firmware 7.02!
If no DCF module will be connected an update to 7.03 is not necessary.
In the case above issue happened the ProfiLux 4 can be recovered by a total reset, please contact then GHL directly.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks