Hi Everyone,
i am new and i can say proud GHL user , so forgive me if my question is a bit annoying but after an hour of searching and reading through the forum i finally decided to post this thread.
I am about to start my 300 liter reef and the equipment from GHL started to arrive, including two of the new Mitras LX 7206 and Profilux 4 ultimate set (still to be delivered).
I have 4 level sensors, leak detection, one flow sensor and additional Digital temp sensor.
2 level sensors will control the AWC which is done by small pumps (i am not planning to use the Doser 2SA for AWC), third level sensor controls a solenoid valve for the ATO. The fourth level sensor will control the level in my AWC container.
I know i can use my new Doser 2SA in sleeve mode but i am not sure if the additional 3 sensor inputs (2 level sensors and one temp) on that Doser can be used by the Profilux 4? Can i plug the flow sensor for example to that doser and still get the reading form it on my profilux?
Please advise.