hi manage to see the graphic display.
looks like my chiller is kicking in too often. i wanted to set 26.3 to 27.3degrees...
what is not right?
hi manage to see the graphic display.
looks like my chiller is kicking in too often. i wanted to set 26.3 to 27.3degrees...
what is not right?
increase hysteresis!
this is my current setting.
sorry i dont understand how the hysteresis work
can someone help me with the hysteresis setting on the graphic above?? my chiller is kicking in too often.
simple: increase the value for the hysteresis until the switching frequency is OK or you, maybe start with 2°
increase the 1 on the left or on the right(under the 1-10V)?
the left value belongs to hysteresis
GHL_1.JPGGHL_2.JPGHi I have a similar problem as the earlier mentioned one - when I read and save my graphs they come up with values totoally unrelated to what the actual sensor values are (ie pH 0.4, temp 71C). How do I fix this?
I have a profilux 3, firmware 5.00, PC software ProfiluxControl 5.0.1.1. Screenshots attached
Any help greatly appreciated
Thanks
Laura
how did you load the data - over LAN, SUB, RS232 or WLAN?
the only thing I could imagine is a transmission problem, or a change of the sensor configuration during the recording period
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
I have a laptop linked to the P3 by RS232 with USB converter. I have been trying to download date for the last few days so I dont think its a sensor configuration thing.
Bookmarks