The bootloader mode is activated by GCC when you perform a firmware update (when going through the firmware update wizard).
After a few seconds the doser stops normal operation and waits for the new firmware, it is in the bootloader mode then.
You say you go through all steps of the update wizward and the the doser goes not into bootloader mode?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks