First of all hi to you all,
I would like to make my Red Sea 250 lights dimmable so I would like to know if purchasing a profillux II and 3 dimmable 2X39watt ballasts (to replace the old ones) is the only things I need to achieve my purpose?
First of all hi to you all,
I would like to make my Red Sea 250 lights dimmable so I would like to know if purchasing a profillux II and 3 dimmable 2X39watt ballasts (to replace the old ones) is the only things I need to achieve my purpose?
I recommend also the product "EVG-AP", switches the mains power on/off and makes wiring easier
http://www.aquariumcomputer.com/Down...G-AP2_V400.pdf
About the EVG's what do I need?
this
(PL-0307) EVG, 2x39W-T5
or this
(PL-0321) EVG, 2x39W-T5, 1-10V-Interface
if you want to dim: a ballast with 1-10V-interface
An what more shall I need to make an auto top off system except from a level sensor?
you can program one of the sockets of our powerbar to be activated if the water level is too low
then you can switch a solenoid or a pump to refill
A countainer to hold the water and a pump to pump the water from said container to top up the tank. The pump is plugged into an outlet on your powerbar.
So items required:
1 x water container
1 x water pump
1 x spare socket/outlet on your profilux powerbar
Length of hose from container to sump or display tank.
Be sure to install the top-up system in a way that does not allow the water to back syphon/drain your sump or display tank.
Bookmarks