Good afternoon,
I'm assembling a Profilux 3.1T, firmware v6.16.
The Profilux has also an expansion Card PLM Temp+pH (to check another system) and the temperature on that one is doing great when compared with my system chiller and YSI multiparameter probe.
The Temp from the probe connected to Profilux is measuring less 1ºC than the YSI multiparameter probe, whick I know is accurate.
How can I change it since it comes calibrated from the fabric?
From reading from other threads I tried to find the "Adjust temperature" in GHL Control Center but with no success ...
Waiting for your answer ...
My best regards,
Lénia
Bookmarks