Hi Andy,
it seems the original calibration data disappeared after the update and had been reset to default.
Or another possibility: The sensor order has changed after the udate and you reloaded the sensor settings.
Did you add/remove sensors or change the order (e.g. swapping EXB on the PAB bus)?
Each EXB comes with a paper where the calibration values are mentioned or they are printed on the bottom of the enclosure.
Did you save the sensor data before the update? Then the calibration data should be in the file.
If all attempts to find the calibration data fail then you should do the temperature adjustment.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks