Hi,
I attempted an update of a Profilux Touch, however it looks like instead of updating the Touch the new firmware was flashed to the Powerbar.
After firmware update and system reset the firmware version on the Touch did not change, but the Power Bar stopped working.
After powering up the Power Bar:
1. The green "Pwr" LED turns on
2. The orange "Comm" LED brinks for around 1-2s
3. The green "Pwr" LED starts blinking around every 1s
4. GHL Control Center cannot detect the power bar
5. Other PAB devices are detected correctly (Touch and Vortech controller)
I am using Profilux 3.1EX with firmware 6.20 and GHL Control Center 1.0.7.7
Help urgently needed.
Bookmarks