controlling Doser2

[firefish128]

Does any of the products GHL puts out automatically install the drive so it works on the first try? can somebody please walk me thru the manual install of the driver for the doser2? Thank you

[Vinny]

Hi,

The Doser 2 driver should automatically install itself when connected to your PC for the first time. If it does not, please follow these steps:

1. Go to “This PC” or “Computer” and click on your hard drive which may be labeled as “(C”
2. Click on “Program Files (x86)”
3. Click on “GHL ControlCenter_V1xxx” (Your current version of GCC)
4. Click on “Driver”
5. In that folder, you will see two files. One is named, “dpinst_x64” and the other is
“dpinst_x86”
6. Click on one of them and follow the install command prompts.
7. After the driver has installed, you should restart the computer and try to connect to your Doser 2.

I have a detailed user manual I can email you: Please send me an email at info@ghlusa.com

[firefish128]

Did everything you said,
still will not connect!!

[PIWAWT]

Hi,
Disconnect the doser from your PC, restart your PC, then follow the steps #2
then connect your doser

regards Pit

[firefish128]

still didn't work

[firefish128]

a few observations
it says program files but no (x86)
GHLcontrol center VX1057, correct program? works with my LEDs
dpnist_x64 will nor run on my computer, it says to find a version for the PC check with the software publisher
dpnist_x86 did install, but still won't connect