-
Change illumination run transmission via PLM-PWC
Hi
I just got my PLM-PWC module. By default does the PLM-PWC card transmit illumination run 1-9 (correct?)
Is it possible to change this to say 11-19 instead (since I have other led light configurations on illumination run 1-10 already)?
If the answer is no, is there any way to copy or move the existing data from the configured illumination runs (so you don't have to retype all set points again)?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks