controlling tunze ATO for salinity

[Hendrikherry]

I am trying to use my tunze ATO by turning it on and off , with desired conductivity range.
tried this but seem like it is not working.

1. set programing logic 4 " always off and conduct decrease "
2. set programing l5ogic 5 " always on and conduct increase "
3. set programing logic 6 " programing logic 4 and programing logic "
4. assign tunze ATO to socket 16 and set as Progaming logic 6
5. conductivity set to 53.0ms hysteresis 0.4

nothing happened when conductivity up to 53.3ms

Please Help

Thanks

Hendrik

[Vinny]

In order to setup Salinity control you need to select the socket which will be responsible for turning on when salinity is too high.

There's no need to use Programmable Logic for this setup.

- Select a socket and set it to "Cond. 1 Decrease."


When the salinity probe detects that your salinity is 0.4 above the desired value, the designated socket will turn on, then shut off when salinity has reached the desired range.

[GazzMan]

No that does not work, please see my other thread