New GCC 1.0.8.2

[Matthias]

New in V1.0.8.2:

!THIS GHL CONTROL CENTER AND THE INCLUDED FIRMWARE ARE STILL BETA VERSIONS! Althoug strict testing bugs can't be excluded!


GHL Doser 2 Standalone can now also be used as a slave device (e.g. with ProfiLux 3 or another GHL Doser 2 Standalone). Additionally the color code of the GHL Doser 2 has been reworked, as a result we have more and clearer codes now.
The new features require firmware 6.25 for ProfiLux 3 and firmware 1.17 for GHL Doser 2 (Standalone and Slave) (included in this GCC version).

https://www.aquariumcomputer.com/dow...enter-v1-0-8-2

[Gael]

YESSSSSS!!!! Thank Matthias :-)

[Gael]

That work :-)

Just one question, to be sure, i can copy calibration value from standalone mode? they still the same?

Thank

[Vinny]

If you're still using the same exact pumps, then yes the calibration value will also be the same.

[Jerel1]

Where is the appropriate section to provide feedback regarding this Beta release?

My ProfiLux 3.1T- FW6.25 responds with an alarm of PABCOM when my Doser 2 Standalone-FW1.17 is configured as Slave mode, though. The Doser 2 LED pulsates blue and then blue and red after a few minutes.

Doser 2 displays version 9.99
I can Manual dose from ProfiLux via GCC 1.0.8.2

[Gael]

Does unassign it et reassign it to the PAB bus solve the problem?

Do you have set doser pumps numbers:
1. Go to "System", click on "PAB", select "Slave Doser 2".
2. Click on "Configuration"
3. Set the numbering of the doser pump.
If this is your first doser, you select "1" from the box, the rest of the numbers are automatically assigned; 2,3,4.
If this is your second doser, you would select, "5" from the box, the rest of the numbers are assigned to 6,7,8.

All work well for me with my 2 dosers. I had the PAB alarm problem and unassign them et reassign them solved the problem.