no, only the ProfiLux sees his "Slave", the doserShouldn't i be able to see communication between the Doser 2 and the ProfiLux via GCC-Doser 2?
but the doser not the ProfiLux
you assign the doser to the ProfiLux, but not the ProfiLux to the doser
did you do assignments in both directions?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Ok, assignments were made by assigning the Doser 2 to ProfiLux for the first few attempts. I tried both directions after no success.
I have a Vortech Controller and a 5.1 Powerbar that communicate without error, works fine.
Also, when assigning the Doser 2 to ProfiLux. There is a high frequency noise(similar to alarm)coming from the Doser 2 while the ProfiLux alarm is on.
this is the alarm buzzer
if you don't want to hear it during an alarm then you need to deactivate it
are both devices updated?
P3 6.25
Doser 1.17
?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
I ended up re-flashing the Doser 2, ProfiLux and reinstalling GCC.
Changes..
Doser 2 now pulsates white LED in Slave Mode
Doser 2 pulsates white and red when being assigned to ProfiLux, Alarm.
white pulsing means that the Master (here: ProfiLux) is trying to establish a connection to myGHL
red pulsing means there is an alarm
I don't know if this is wrong in you system
we couldn't find any bugs in these firmware versions and in GCC, so we decided to change the status to "Release" today
PS: if you still have problems please contact us directly by email, we want our 2nd level support handle this
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks