New GCC 1.0.8.0 and new firmware for ProfiLux 3 and GHL Doser 2

[Matthias]

New in V1.0.8.0:
Support for magnetic stirrers, myGHL Read-Only-Access added, other improvements.
The new features require firmware 6.24 for ProfiLux 3 and firmware 1.16 for GHL Doser 2 (Standalone and Slave) (included in this GCC version).

https://www.aquariumcomputer.com/dow...enter-v1-0-8-0

[Gael]

Hello

Thank but not all is good.

Firmware upgrade of Doser 2 factory reset ALL settings, ok i recover from settings.par and write back refill container value BUT even wifi go down: My two doser go from AP to client mode... I see Doser 2 wireless network on my computer and dosers are not connected to my wireless network. I had to reapply wifi settings to get them work again.

Also several problem with Profilux, it lost ALL settings and all sensors history, ok, recover from setting.par and sensor data.par do the trick except lost all sensor history. BUT PROBLEM, now, Constant Flow don't work, Flow sensors settings are set to 0 and change are not keep when close and reopen windows...
Capture d’écran 2016-02-02 à 23.53.55.png
What can i do?

Thank

[Gael]

Hello,

Can i hope to have some help?

Thank

[Matthias]

thank you for your hint

we examine this flow sensor issue and come back to you ASAP

[Matthias]

meanwhile we were are to reproduce this issue and to locate it, GCC doesn't display correctly (the ProfiLux firmware is OK)

it has been fixed in GCC 1.0.8.1

we are doing some tests with the new GCC version, we will upload it ASAP

[Gael]

Ok.

Thank Matthias :-)