I can not connect through my WLAN card. I can connect to it directly and look at its configuration which has the right ssid, static IP address, baud rate of 9600 on serial 1 and the baud is set as 9600 on the WLAN serial part of the Profilux. I have set the static IP address in the connection dialog box of the profilux software and if I hit configure it takes me to the cards configuration page.

However, it will never actually connect through the Profilux software. Both the green and red lights on the wlan card are on and the red stays permanently red and does not flicker (which seems suspect to me). My firewall is turned off.

I have a USB serial card installed also. When connected by USB, I can see the WLAN card in the systems section and it appears to accept the SSID and IP address when I type then in here. When I save on the configuration screen, the Profilux gives a message saying it is resetting the module so it can clearly see it.

Any ideas on what might be wrong?