GCC 1.0.7.7
firmware 6.22
p3 unit
im trying to "transmit all settings from profilux to file" and i get an error message about
"cannot open parameter definition file"
i can transmit the "all sensor data"
thanks!
GCC 1.0.7.7
firmware 6.22
p3 unit
im trying to "transmit all settings from profilux to file" and i get an error message about
"cannot open parameter definition file"
i can transmit the "all sensor data"
thanks!
Please - see my post below - Problems with GHL Controlcenter vers 1.0.7.7 samt firmware 6,22
Sincerely Lasse
thanks lasse!
Bookmarks