Problems with GHL Controlcenter vers 1.0.7.7 samt firmware 6,22

[Lasse]

After updating to 6.22 (from 6.18) I got in trouble. When I try to save the settings data I´get the following message (se picture 1). The file does not exist as you can see at picture 2
However the saving of the sensor data and the SMS module settings works as it should.

Screen Shot 12-01-15 at 03.55 PM.PNG

Screen Shot 12-01-15 at 03.59 PM.jpg

Another problem is in the web server. I do not get the graf under settings. The overview works but not the individual graphs Pictures 3 and 4

Screen Shot 12-01-15 at 04.12 PM.jpg

Screen Shot 12-01-15 at 04.13 PM.jpg

What to do?

Sincerely Lasse

[Lasse]

I have tested two different 3.1T computers - same results

Sincerely Lasse

[Lasse]

Hi again

I have done some testing with a third Profilux 3.1T according to firmware updating. With 6.22 I got exactly the same problems I got with the other two systems. Could not save the settings with the same answer (see picture 1).

sjöfart 074.jpg

In the web interface – I could not use the individual settings page. (See picture 2.)

sjöfart 075.jpg

Downgrading to 6.21 solve the problem with saving the settings but not the web interface problem

Further downgrading to 6.20 solve both problems.

sjöfart 076.jpg


I´m sorry to say but for me it seems as it is a bug in firmware 6.21 and 6.22 or in the Control Center 1.0.7.7

I have use Control Center 1.0.7.7 from the 2015-11-28 Have not tested with 1.0.7.6

Sincerely Lasse

[Lasse]

To resolv the first problem - can I simply copy the file ParaList_V621_Profilux3T.def and rename the copy to ParaList_V622_Profilux3T.def and place it below the file ParaList_V621_Profilux3T.def at the directory C:\Program Files (x86)\GHLControlCenter_V1077 ?

Sincerely Lasse

[Vinny]

Hi Lasse,

Thank you for bringing this to our attention. We will look into this asap.

[Lasse]

Thank you Vinny

My two large systems are up and running with firmware 6.22 - it will take me a couple of ours to downgrade or upgrade them. I can´t save the settings - therefore I will have a lot of problems. I would prefer that you do a fast fix with the .def file I need - and send it to me for a manual upgrade of the actual directory) in order for me to save the settings before downgrading or upgrading (we changes the setting rather often because there is 29 feeding machines and a lot of pumps anf programic logic connected to this two computers)

I run 6.20 at another large system (a public aquarium) since three weeks ago and it seems stable

Please - let me know how to do it.

Sincerely Lasse