Hello I'm looking for a solution.
The aquarium has two water sources:
1) Fresh water top off (socket x)
2) Saturated salt water top off (socket y)
There is a pump on timer A which removes water from the tank daily
I have a conductivity probe, I originally had it setup as follows:
Socket x = Programmable Logic - Water 1 AND Conductivity Decrease
Socket y = Programmable Logic - Water 1 AND Conductivity Increase
However if setup this way and conductivity is at nominal value nothing happens (top off doesn't activate).
Is there another alternative? Preferably one which works with the float and will not activate socket x and y together (same time).
Also if possible can the pump on Timer A be deactivated if an alarm is activated? If salt supply runs out I don't want the pump to continue removing water until salt supply is refreshed and alarm reset.
FYI I'm using Profilux II controller with most recent firmware.
Thanks!!
Bookmarks