Hi
i'd like to know how can i drive with a profilux 3.1Nex a 12v & 1,2A mixer motor for a kalk reactor
do i need a special card ?
thanks
Hi
i'd like to know how can i drive with a profilux 3.1Nex a 12v & 1,2A mixer motor for a kalk reactor
do i need a special card ?
thanks
will it be possible with a PropellerControl-2.1 ?? as fans run at 12v??
thx
you can use a Powerbar
Which port?
and is possible with the new powerbar 5.1?
thx
it is a controllable motor (which control? PWM or 1-10V?), or are you just on / off.
If you need only on / off, you can use the Powerbar
it's gonna be for a neo3plus kalkwasser you can see here: https://youtu.be/QHFTEd85N-U
great products by the way
the motor run with 12v and 1,2A
i just want the profilux run him 10-15 sec every 30 minutes
will it be possible and where ?
thx
the motor run with a 110/230V AC/DC Adapter?
Then you can use a Powerbar with the Timerfunction in the GCC , but the smallest interval in the timer is unfortunately only 1 min
If you have a normal 110v or 220v plug, then the powerbar can be used with timer functions.
NO, the electrical connection is a : Jack mâle 3,5mm mono, not sure i can stick it in the profilux or powerbar
because it usually goes with a timer who can allow to run ON from 1 seconds to 60s and OFF from 1min to 7days.
If it's not possible i'll buy the timer but i wanted to know it before.
Bookmarks