No QD functions.
No QD functions.
Perry
A screen shot is worth a thousand words...
Profilux 3.1N eX, 3 PAB 6D, Slave Doser, PLM-ADIN, Vortech Controller, PLM-PWC, Leak detector, 2 LX 6100HV Mitras
Controlling a 150 DSA Peninsula mixed reef.
I was gonna upgrade my controller but i guess i should wait..dont even see any responds from GHL support team in this matter ..
We are working on an update to support QD functions.
So if I have qd pumps I can't pair these with ghl - vortech wireless controller correct?
I give up tried to do this 20 times getting error all the time.
Mine doesn't even see my pumps anymore, I'll wait for the firmware update to do anything with it.
Perry
A screen shot is worth a thousand words...
Profilux 3.1N eX, 3 PAB 6D, Slave Doser, PLM-ADIN, Vortech Controller, PLM-PWC, Leak detector, 2 LX 6100HV Mitras
Controlling a 150 DSA Peninsula mixed reef.
Yea, mine either...
But it's a little bit disappointing, qd drive is on the market since April if I'm not wrong.
I have also 3 pumps - one "old" MP40w and two new MP40w QD. basically old pump is shown OK in controlling view, the new QDs - are shown as UNKNOWN and no special features available.
Since may 2015 it's like 7 months - very promising.
My mp 60 qd is seen as a mp40 something, something... (Don't remember exactly). I can't see firmware version.
It works but not at 100% speed, I wold say maybe 70%
Older pumps are ok.
For those following I just updated firmware to 6.23, still no joy. Maybe the next update will address this issue.
Perry
A screen shot is worth a thousand words...
Profilux 3.1N eX, 3 PAB 6D, Slave Doser, PLM-ADIN, Vortech Controller, PLM-PWC, Leak detector, 2 LX 6100HV Mitras
Controlling a 150 DSA Peninsula mixed reef.
Bookmarks