Changing 6200 to 6100

[The Codfather]

I am going to be changing out my 6200 pucks for the 6100 series soon. Is there anything that has to be done prior to changing the boards out? I know I can change the settings in GCC to have the programming come into play, but was wondering if there is something I need to do prior to powering up the unit after the 6100 pucks are placed in.
Thoughts? Any help or tips would be great. Thanks in advance.

[doggydoc10]

Did you buy the pucks already? I have a 6100 I can always switch with you!


Always at Sea

[The Codfather]

Sorry Doc, found someone on our local forum to trade with already.

[doggydoc10]

Ok.
Good luck. Figure I try!


Always at Sea

[Vinny]

To configure the Mitras LX for the new LED clusters, please follow these steps:

1. Connect to your GHL Mitras LX via USB
2. Click on “Extras”
3. Click on “Change Model” in the Hardware section
4. Select the Mitras LX version which applies to the new set of LED clusters
5. Reset the Mitras LX and program your new channels.

Mitras Cluster Swapout Instructions.jpg

[The Codfather]

Thanks Vinny.

[Vinny]

No problem.