Ok am I doing something wrong
I can only get the control to work on an unsplit L line
if I connect it via a splitter it no longer works
surely the propcontrol doesn't need 2 L lines
or am I mistaken ?
Ok am I doing something wrong
I can only get the control to work on an unsplit L line
if I connect it via a splitter it no longer works
surely the propcontrol doesn't need 2 L lines
or am I mistaken ?
It only needs one channel.
Perhaps it makes sense to change the channel on which PropellerControl reacts? Please have a look in the manual, it is described there how to make this.
Doh RTFM
never was good at that
thx
open PropellerControl, place both jumpers to the other pins (2-3 instead of 1-2)
what do these jumper do??? or where can I find the manual as mine is long gone...
Thanks
when plugged on 1-2: reacts on channel 1 (3, 5, 7...)
on 2-3; channel 2 (4, 6, 8..)
Bookmarks