How to set RAMP on Mitra Light bar

[Vim1zn]

Hi,

how would i set each channel to ramp from 0-100%
for eg : if i wanted the lights to start coming on at 09h00
and i wanted ch1 , ch2 , ch3 and ch3 to start coming on at 09h00 and reach 100% at 10h00.
then vice versa , drop from 100- to 0%

The Light bars don't see that bright as well - i mean i can look at them dead.
also doesn't "pop" zoo's i have sitting on the ground .

is there a way to also make them brighter

thanks for your help

[Artur]

You can use the LightComposer to set up the channels.

The Light bars don't see that bright as well - i mean i can look at them dead.
also doesn't "pop" zoo's i have sitting on the ground .

is there a way to also make them brighter

You can change the max. output under illumination -> Mitras Lightbar.
If you want see how bright the lamps are you can set the output to 100 %, go to illumination -> light scenarios, check "Activate manual illumination" and click the 100% button.