Results 1 to 3 of 3

Thread: Unable to Dim Light Bar via GHL software

  1. #1
    Join Date
    21.01.2015
    Posts
    17

    Default Unable to Dim Light Bar via GHL software

    Hi,

    -Serial Cable has been connected to profilux
    -Serial Cable female has been connected to LB splitter
    -light bars have been connected to Splitter
    -splitter has been connected to power supply
    -power supply has been turned on - but when I try to use the software to control it or each channel it stays on 100%
    soon as its plugged in it goes on 100%
    help please

  2. #2
    Join Date
    06.02.2012
    Posts
    2,020

    Default

    You have to assign the RS232 port to the lightbar first

  3. #3
    Join Date
    21.01.2015
    Posts
    17

    Default

    Hi thanks

    Managed to get this going just before you replied . Would have been good to have a manual though esp for the initial setup.
    Is it possible for me to change the illumination channel colors ?

    Also whats the depth these will get too.
    Last edited by Vim1zn; 30.06.2015 at 10:46.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •