How to use the dimm socket on the powerbar5.1?
If you can give me an instruction.I would be very appreciative
thanks in advance
kurt
How to use the dimm socket on the powerbar5.1?
If you can give me an instruction.I would be very appreciative
thanks in advance
kurt
Hello,
you connect with GHL Control Center to your ProfiLux, go to System, select the PowerBar and click the configure button.
PB51_Config.jpg
Set the dimm channel you wish and the PowerBar reacts to this channel. The dimm channel you set reacts to the illumination channel.
If you set the channel number to 5, the PowerBar reacts to illumination 5.
PB51_Channel.jpg
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Hi,Artur
I'm confused to the dimming method.What's the difference between L-port and dimming socket? I know, the L-port outputs control signal,the dimming socket outputs electric power. Can I use the dimming socket to dimm a T5 or metal halide without 1-10v port ?
thanks for your reply
kurt
Hello,
you need a dimmable electronic ballast for the T5 or metal halide. The dimming socket can be used to dimm dimmable pumps, fans, heater, halogen lamp, etc.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks