Hello,

I have had some water damage on my equipment, my profilux 3 was destroyed, so I bought a new one, just arrived yesterday. (thanks to my insurance company)

Now, I am trying to setup my mitra lightbars, they are on 100% on, the whole time now:

* I go to illumination --> Mitras Lightbars : there I tick on the box 'Mitras lightbar present'

* I go to illumination --> Light Composer : I load the file that I have for my light settings

* I transmit illumination runs to illumination channels

Then, nothing happens, also when I start the test program, no changes, the lights are 100% on, as if they are only connected to the power supply, but not to the profilux.

Is there something I am not doing correct or is there more stuff broken? Since the lightbars are 100% on, I never thought that there would be something wrong with the lightning.