Yes, this option is available.
Over and under value alarm, when the control is out of the normal range.
Start ProfluxControl and connect to the Profiluxcomupter.
Go to the tab / folder Probe/sensor control.
Now go to pH-value 1.
At the right side of screen you have the option alarm.
Options are: Not enabled, Enabled, Enabled expect during AWC
I prefer Enabled expect during AWC.
Set the max deviation.
You can also Deactivate the pH-control.
So when you are using a CO2 system it will shut down the CO2-falve.
Set under the general tab/folder under alarm on the right side of the screen the buzzer mode.
When you set an certain time the alarm will only go on during this time. Start time 8.00 End time 22.00.
Than the buzzer will not go on during the Night.
Last edited by Martin van der Wal; 07.03.2009 at 10:31.
Best regards, met vriendelijke groet,
Martin van der Wal
_________________________________________
Aquarium 160x50x50, bioloog 80x40x40.
3 daglicht TL-lampen 1-10V dimbaar.
1 Blacklight TL-lamp 1-10V dimbaar.
Moonlight + onweer
Temp. regeling 1x pT1000 + Hydor ETH200 + bioloog verwarming.
pH regeling met CO2 toevoeging + beluchting.
Niveauregeling met automatisch waterverversen
Bookmarks