Problems to start controlcenter on pc v 1068

[anders]

Hi
I have problems with ghl controlcenter v1068
The program was ok, until i make a different range of the unit i the left corner.(moved profilux 1 from bottom to top)
After that i cant start the program, firmware 6.14 profilux 3.1T

profilux.jpg

Best regards
Anders

[Artur]

You can't start the program or you can't connect with the ProfiLux?

[anders]

I cant start the program, it never comes further than the screendump i have attached. (the program dont answer, is the message )
Have reinstalled the program several times.
I have installed GHL on my old pc (vista) this Works ok. Use 8.1 on the pc with the problem.

[Artur]

Maybe you activated the autoconnect, try following:

1. open the registry editor (http://pcsupport.about.com/od/regist...try-editor.htm)
2. Navigate to HKEY_CURRENT_USER -> Software -> GHL -> GHL Control Center -> Settings
3. double click AutoConnect and change the value to 0

registry.jpg

[anders]

The program is running Again :-)

Thanks a lot

Hilsen Anders