New GHL Control Center version 1.0.6.7 for Mitras, ProfiLux and GHL Doser 2

[Artur]

...is available now.

With this version the GHL Doser 2 firmware version 1.07 was added.
The firmware version 1.07 was optimized for myGHL and is now required for myGHL.

Following changes were made in the GHL Control Center version 1.0.6.7:

• Dose specific amount for GHL Doser 2 added
• myGHL settings changed
• Further improvements

Following changes were made in the GHL Doser 2 firmware version 1.07:

• Improved stability and security of the myGHl connection.

You can find the new GHL Control Center version in our download area.

[candyyc]

Installed the new control center and upgraded the firmware to 1.07 yesterday.

However, right after the upgrade, my wifi connection no longer work, which is working properly with previous version. I can still able to ping my doser address in my network as before. Currently, I can only control the doser with direct USB connection.

In addition, when I try to add device to myGHL.com, it prompt that my device not find or not correct version 1.07! But I saw my doser on the drop down list!! I use the same setup and connection before with previous myGHL.com with no problem.

Please advise how to resolve this problem. Thanks

[Artur]

Hello,

please check the wifi settings and restart the doser (unplug power cable for at least 15 seconds).
If you still have problems, we can make an appointment for a remote session.

[candyyc]

Hello,

please check the wifi settings and restart the doser (unplug power cable for at least 15 seconds).
If you still have problems, we can make an appointment for a remote session.

Retried few times, still not able to setup. Please let me know how to setup appointment for remote support?
Thanks again for your help