Mitras 6200 connection problem

[enzo0000]

I can only get 2 of my 3 light to connect to the GHL Control Center. Can someone help please.

If I want to make one a master and the others slaves, will the 1 that will not connect be able to receive my lighting schedule?

I wanted to have 1 light on a different schedule.

thx all

[doggydoc10]

I believe you have to make the Profilux master and Mitras slaves.



Always at Sea

[enzo0000]

I don't use a profilux. I need to know why my 3rd unit will not connect to the control center

[enzo0000]

Anyone?

[T rose]

Anyone?

Just a quick thought, not really experiences in these matters as I just got my set and used them!

Have you tried setting up the unit you want an a separate function as a standalone on the control panel of the Mitras itself? As I found none of the slaves will respond only the master?

[enzo0000]

I don't think you can setup a lighting schedule from the panel on the light itself.

Anyone else....

anyone know how we can get support for these lights????

[Artur]

I can only get 2 of my 3 light to connect to the GHL Control Center. Can someone help please.

You need a USB cable for the connection between the GHL Control Center and Mitras.
If you can connect two of your Mitras with the USB cable and the third not, it seems the third is faulty and you should contact your retailer.

If I want to make one a master and the others slaves, will the 1 that will not connect be able to receive my lighting schedule?

IF you change it to slave directly on the lamp it should receive the master signal.

[enzo0000]

If you can connect two of your Mitras with the USB cable and the third not, it seems the third is faulty and you should contact your retailer.

I purchased them at different times to 'build' up the equipment needed to start the 180, this has been a long process and I couldn't start it until I purchased my house. I'd say i've had them about a year give or take. I plugged it in when I got it to make sure it worked, which it did (did not plug it in to the computer though). Since then it has been sitting in my closet in the original box. The retailer is now closed, but it was a special order from your rep in Canada then shipped to Houston. What are my options now?

[Artur]

Since then it has been sitting in my closet in the original box.

OK then make sure the USB cable is Ok, use the same cable for all three Mitras.
Change the connection of the Mitras in the GHL Control Center like this:
MitrasConnection.jpg
and try to connect all three Mitras.

The last thing you can do is to check your device manger (http://www.computerhope.com/issues/ch000833.htm).
If you connect the Mitras one by one with the USB cable to your PC, you should see a device with the name "GHL Virtual Communications Port" for each Mitras.
MitrasDeviceManager.jpg

If you still can't connect the third Mitras and you don't see the "GHL Virtual Communications Port" device in the device manager for the third Mitras, it is possible that the Mitras is faulty.
You can contact Michael Hall (info@ghlna.com) in Canada or info@ghl-kl.de here in Germany.

[enzo0000]

I will try using the same USB cord, I used the USB cord that came with each light because I did 1 light at a time and then packed them back up. All connections to GHL Control Center were set to 'AUTO'.

I'll also check to see if "GHL Virtual Communications Port" is showing up for the lights. I'll keep you posted.

Thanks again for helping.