Hi
Update of the main P3 went well with no problems , a few minor settings had to be manually updated afterwards but nothing major. I did need to use the Profilux control software to update the...
Type: Posts; User: jimdoniom
Hi
Update of the main P3 went well with no problems , a few minor settings had to be manually updated afterwards but nothing major. I did need to use the Profilux control software to update the...
Ok so the new GCC will work to upgrade even though the P3 is on an earlier than supported firmware, this previous reply seems to indicate that I'd need to update using the existing Profilux control ...
Hi
Not had to do anything to my profilux for many years it has run faultlessly, currently running firmware 5.14 profilux 3eX I have one powerbar 6D -UK attached. I am using Profilux control version...
can anyone say how to do it?
OK I understand that, that will work for me now all I need to understand is how to stop the constant alarm condition of sensor 3, and whether I need to add any programmable logic to get all three...
it is from here that I am not sure what to do next, I would like to set it so that I only get an alarm if the third sensor shows the water level in the top up container is too low... but from what...
I understand, I'll try that and wait for a comment from the GHL guys on the alarm issue as that too causes me concern
Thanks, I'll have a try just substituting level3 where you have level 2.
I do think we need a reply with an answer on this alarm though, it must be possible to set it up so that it works after all...
any chance you can post what you did so it may help me fix my problem?or maybe Matthias can continue where you left off and continue to guide me on the next step?
I have now done that the levels 1 and 2 appear to work correctly, and I have set level 3 up as return pump but I keep getting an alarm on level 3.
I'm not sure if I need to add something else...
Hi Matthias
Thank you this is exactly what I want to do.
I have sensor one connected and it is working on it's own as ATO
I have set the socket No5 to water1
This is working OK with a...
I have looked at that, and yes some of it points me in the right direction , but all the screens i see on the software are now different and I do not know if it is correct. I just don't understand...
Can nobody help?
Hi can someone tell me what settings I should choose and/or have to make to have ATO operate with three sensors.
Sensor one as a low level sensor to turn ATO on , sensor two as a safety high level...
problem is now solved, it was the contacts on the lightstick plug.
I checked them after a conversation with chippypah from UR, and all seems fine now
thanks for the response though.
Hi Matthias
Yes I have checked that the illumination channels in 1-10v interfaces all match.
L1 is set to 1, L2 is set to 2, L3 is set to 3, etc.
Hi wonder if you can help
I have a problem with a full weather light stick , this is on a P3 Ex. firmware 5g. the blue and white lights run and do what is expected and appear to be on channel 1,...