Update:
I recented ordered a new Dali card , connected it and all works fine.
Type: Posts; User: aquatixguru
Update:
I recented ordered a new Dali card , connected it and all works fine.
I tried again.
I connect 1 ballast (tried with each on of the 3)
When I run new numbering on the profilux itself it reads Ready - 0
When I click assign and I choose 1 it turns off the lamp that...
did you solve this problem?
I am having the same issue with similar ballasts
Ok it works now normally.
Thank you
Any clue on how to wake up a socket on a thunderstorm event using progammable logic?
I want to wake up a timer set socket that a tunze turbelle is on from 7pm to 12am. but only wake it up in...
I have tried to calibrate from the profilux itself.
but I still get the same values in ADC no change.
the problem is I did not write down before changing them.
Is this what the calibration...
Thank you Matthias for your prompt reply.
Thank you Matthias,
I will check again connections and give it another try.
Are there any pictures of optical level sensor mounted? I got some parts
optical level sensor but I dont know how to mount them. inside or outside the tank?
is ther a picture with PL LF base...
I get no reading in heater sensor.
It was showing ok 26 celsis and then went to 37 celsius.
I reset it now it show 40
and ADC is 20 - 0
30 - 0
Is there a way to get the default factory specs...
Hello, everyone.
I am new to profilux and I am trying to connect the
Dali interface to the osram quicktronic 2x54W ballasts.
As I run the recognise funtion on profilux I do not recognise the...