Search:

Type: Posts; User: diverdan

Search: Search took 0.01 seconds.

  1. calibrate PH with the P3(must enable probe first)

    Just a heads up. You will not be able to perform calibration unless you first enable the PH probe on the controller. Enabling and calibrating are done easiest on the Profilux itself, not the pc...
  2. Replies
    13
    Views
    30,544

    Great answers and photos, I too, have a piece of...

    Great answers and photos, I too, have a piece of acrylic next to the sump. I am going to dose 2 part for now, see how it goes. I have yet to order the dosers but your pictures are very helpful. Good...
  3. Replies
    13
    Views
    30,544

    Great photos! Two questions: 1) Are you...

    Great photos! Two questions:
    1) Are you concerned about humidity affecting your controller/doser? it looks like they are right up against the sump.
    2) Are you dosing zeozym manually? I see the jar...
  4. Replies
    6
    Views
    3,504

    Blahenazo, How then is it mounted to the...

    Blahenazo,
    How then is it mounted to the proble holder assembly? The mounting bracket is made only for a vertical fit?
    Thank you again!
    Rich
  5. Replies
    6
    Views
    3,504

    OK, question: I have the optical sensor. The...

    OK, question: I have the optical sensor. The instructions state to set this HORIZONTALLY and have a photo to confirm this. However the picture of the mounting hardware on the GHL Direct site shows...
  6. Replies
    6
    Views
    3,504

    thank you very much

    thank you very much
  7. Replies
    6
    Views
    4,572

    I got the wireless feature working after buying a...

    I got the wireless feature working after buying a gaming bridge and first getting my FIOS router to recognize it. Then I assigned the P3 an IP address. It took a day and a half and I am not sure I...
  8. Replies
    6
    Views
    3,504

    ATO set up instructions?

    I am attempting to set up my ATO system with the P3. I have looked in the manual and cannot find any. Is there a diagram or instructions anywhere? Thank you.
Results 1 to 8 of 8