@MatthiasF - Could you specify how to interpret that format? Source-id, Source name are naturally clear, but details, value 1 (seems to be measurement value to be divided with 1/10/100 depending on...
Type: Posts; User: samwise
@MatthiasF - Could you specify how to interpret that format? Source-id, Source name are naturally clear, but details, value 1 (seems to be measurement value to be divided with 1/10/100 depending on...
Hi,
So what is the most up-to-date advice to deal with this? GHL Control center ends up in communication error 28 with 100% certainty in about 5-20min of being just open. Connection is with Wifi...
Hi, and thanks for your answer.
No I don't have direct access to another test kit, but this is not expired one. It is valid until end of 2020 and opened just few months ago. And I did not notice...
Hi,
Unfortunately I need to report the similar behaviour of KH director, something that makes "adjust displayed measured value " correction hard to use. Specs of the installation below:
- Reagent...
Hi,
Trying to figure out how to connect two temperature probes to Profilux 2 Plus Ext computer. Does split cable work like it works for level?
Or does PLM-pH-Redox-DigTemp Sensor (PL-1258) and...
Hi,
Trying to figure out how to connect two temperature probes to Profilux 2 Plus Ext computer. Does split cable work like it works for level?
Or does PLM-pH-Redox-DigTemp Sensor (PL-1258) and...
Ok, thanks. Signal filter is different thing from the calibration tolerance? Haven't seen that kind of an option anywhere, in which firmware version that should be found?
Sami
Hi,
I have exactly the same problem with my redox probe. Clean and calibrates perfectly, readings are stable in any vessel of water except my aquarium. Swings 20-30 mV all the time. This started...