Matthias,
Sorry for the delay, it still did not work, and I ordered another salinity probe and will post the results once it arrives.
Type: Posts; User: KevinR
Matthias,
Sorry for the delay, it still did not work, and I ordered another salinity probe and will post the results once it arrives.
Sorry for the delay,
Reverting the code back and the probe works now so it is related to the upgrade?
want to make sure I do this correctly?
You want me to revert back both on the P4 and the Exbox to the previous versions?
Do You want me to do the Exbox2 First and then the P4? Or do the P4...
The Expansion Box is right off the P4, less then 18 inches away. I did replace the cable and it dong the same thing.
I then went about disconnecting everything, only leaving the Expansion Box and...
I found the ADC :)
Here is my entire probe settings inside GCC Desktop Software.
11100
ADC?
11099
I do not have a virtual probe for the Cond.(s).
Below are my Current Firmware levels:
P4: V7.16 (Wifi is 6816)
Expansion Box 2: V2.04
Both of My Touches show V1.06.
In the one screen shot the Alarm shows disabled and I still receive the alert in V 1.1.1.8
To revert back, do I a backup of the config as it is today? Or do I restore the config that I had before...
Something did break in the V1.1.1.8 software.
Even after a calibration, the system is still alerting on the salinity probe. I even reseted the Expansion V2 box and the P4.
As you can see even...
I was able to resolve #1 Issue. After a full reset of the both the P4 and the V2 Expansion Box it now seeing the PL-ADIN Card.
I can still not get my salinity probe off from reading 100ms thou. I...
Good Morning,
After the upgrade to this version 1.1.1.8 I noticed two issues:
1: My PL-ADIN card has now stopped working in my V2 Expansion Box.
2: my Salinity port has now stopped working in...