It works again, without my interference.
Det virker igen, uden min indblanding :-)
Anders from denmark
Type: Posts; User: anders
It works again, without my interference.
Det virker igen, uden min indblanding :-)
Anders from denmark
Hi
My webinterface dont show sensor settings, curves of measured data.
Firmware 6.23
Anything i can do ?
Anders
8119
Hi
The timer dont cut off the program running, and shut off the fill valve ?
I dont need any alarm, could see on my floor, i had a misfunction on the upper level indicator, afterwards i entered a...
hey
I have saved a wrong mac addres, how can i rewrite the correct number, it is not allowed to make two entries.
Sorry .-)
Anders
Hello
This messagebox turned up, when it tried to connect to myghl.
I have copied from ghl control center, my ghl id
Its a profilux i have tried with.
Best regards
Anders
Hi
Take care of another magnet near by, the holder to the floatsensor have a magnet that can have influance on the floater levelsensor. if the magnet is to close to the sensor.
Hilsen Anders
The program is running Again :-)
Thanks a lot
Hilsen Anders
I cant start the program, it never comes further than the screendump i have attached. (the program dont answer, is the message )
Have reinstalled the program several times.
I have installed GHL on...
Hi
I have problems with ghl controlcenter v1068
The program was ok, until i make a different range of the unit i the left corner.(moved profilux 1 from bottom to top)
After that i cant start the...