8706
Here it is.
It is currently connected to L1L2 port, but when I change it to L3&4&5&6, nothing changes on the controler
Type: Posts; User: Guillaume
8706
Here it is.
It is currently connected to L1L2 port, but when I change it to L3&4&5&6, nothing changes on the controler
Hi,
I doubled checked the settings.
But I don't get any reaction from the sensor. I tried configurating controls on the L3&4 and L1&2 ports... neither worked :(
What options do I have ?
Dear Vinny,
Thank you for your answer.
Unfortunately, the state doesn't change if I put in and out the level sensors (the 6 level sensors have the same X mark).
The sensor has been cleaned...
I would also say that I tried to connect the level sensor to the additional 4level card, slot 3, but this did not fix the issue. Where can I see if the sensor is sending any signal/information to the...
Hi everyone,
I am facing an issue with my auto-top-off function.
The optical level sensor I have been using for several month does not seem to give any information to my profilux 3.1T.
I...
Hi,
I try to connect my profilux 3.1T to myGHL.
UNfortunately, when I get logged in on myGHL, it asks for myGHLID and when I fill it in from the GCC, it says my GHLID has already been assigned...
Hi, I downloaded v1.2 on my Android cell phone. The program doesnt launch (freezed on a blue screen) any advice ?
Hi !
Yes, problem fixed, thank you !
Thank you very much for the tip !
Hi,
This is an emergency call for help.
I tried to update my firmware with the GHL Controller PC software.
The version of the new firmware is 6.23, for profilux 3.1T
During the writting...
Hi Artur and Lasse. Thank you for your answer.
I donnot find anywhere where I can see what probe slot is for pH and what slot is for conductivity on the expansion card. Both seems to be BNC slots....
Hi,
I also have a mesurement problem with my extension card PLM-CondF-pH, installed on my profilux 3.1T.
The cond. probe is not installed.
The pH probe is callibrated with 7 and 9pH...
Thank you very much for your answer.
I have another question : is the conductivity probe for freshwater (range between 0 and 2mS/cm) suitable to check R/O water ?
Hello PIWAWT
I have been looking at your list.
Are you sure I can connect 3 powerbar 5.1PAB to one Profilux 3.1T ? I could see only 2 slots (S1-S4 / S5-S8) for powerbars. :confused:
Hello !
Thank you very much for your answer.
I have a good overflow on the main tank (this aquarium is an elos aquarium, I never had any issue with the overflow), but the overflows on the...
Hi everyone,
I have a reef system made of 4 connected aqurarium, connected to each other; I would like to centralize the monitoring and control of the equipement.
Does anybody knows the list...