Search:

Hi Thomas - this is a great product and sounds even more efficient and controllable than a MITRAS LX 6200HV!

I want to replace my current system with a Mitras lightbar system. My 2x2x2 reefcube...

Hi Mattias, these are out now. Any word from Ecotech please?

Thanks


Sent from my iPad using Tapatalk

Hello mr Murphy,

I sorted all my problems out...

You need a pab cable to connect the vortech controller you bought from profilux to the pab bus. The connection between the vortech controller...

And the vc is 2cm away from the mp controllers



Sent from my iPad using Tapatalk

Some more background:
Firmware vtc: 1.02
Firmware controller interface: 1.02
Firmware rf module: 1.02

Firmware mp40 gen2: 2.02

On the vc, blue and green LEDs are on and the yellow led...

Hi guys, I just installed a vc unit and have the same issues. Red/blue flashes and no connections. I can however use my vt as master slaves between themselves but not as slaves for the vc...


Can...

Thanks Wirus... I tried that but my temperature is off by 2c too high compared to an electronic meter and 2 high end analog thermometers.


Could it be that the values in the system have been...

Hello
I upgraded my P3 to P3ex and after a few failed software upgrades noticed that my temperature is off a couple of degrees.

I do not have the original ADC values. If they are consistent...

Yup - and it's still 0.0.0.0 - however, on my D-Link router I get the following:

IP Address: 192.168.0.100
Name (if any) PROFILUX3_01
MAC 00:50:c2:b8:12:02

Hi team - first question - my onboard LAN IP is 0.0.0.0

I have tried changing it manually with PLC 5.1 but that does not work. each time I check it on the front screen, it returns 0.0.0.0.
...

I found the command and all is working now.

HOWEVER - the Cond reading on the P3 is equivalent to a salinity (PTU) of 26, or less than 30mS!!! On my dd20 ATC refractometer, it reads 34ppt. One is...

Hi team!
I just upgraded my P3 to eX.
After the upgrade I also uploaded FW 5.07

However, type is still Profilux 3 and the Cond probe reads 0mS.

Any thoughts please?

Hi team - tried to upload the latest version of your software via a USB connection yesterday and it failed.... Need to flash again...

Question : does the flash need to happen via a RS232 cable or...