Thank you Vinny.
Type: Posts; User: ChiFiLux
Thank you Vinny.
How should I clean them and rebuild them? Is there a lubricant I should put back on to the rollers?
Thanks GHL Team.
...
danke schön Matthias! That worked. So simple. This is my first controller, Profilux 3. The previous owner had many good things to say about the quality of GHL. I'm sure he also meant the support too....
Thank you for the response. I will check that too and respond back with a picture.
Tonight I'm going to take the PL3 offline and open the device up to check the internal soldering and components....
Would someone from GHL, engineering or quality, help me out with some failure modes related to temperature functionality and schematic? My company is in the high tech field and make products using...
Thank you for the view and reply Pit.
The ADC 1+2 settings are factory settings. I recorded them prior to firmware update as one Forum chat had recommended.
I have not tried "Calibrate" as I do...
I replaced what I thought was a defective temperature probe today with a new PT1000. In ice water bath, the temperature reading goes up to 131deg F. Putting the Sensor probe into the Aquarium, the...