Search:

you can use a 220v relais.
the pab turns the 220v relais on, and the relais switch your heater on. without using your ups

like i said i offerd you to sent you my eheim pomp so you can test all you want.
my pump is runing at 30% and it's working. when i raise it to 50% the pump goes into auto off and will not respond to...

when settings are to high, i can not change them because the filter is ignoring the command.
and we sent a lot of mails regarding this poblem.
when choosing feeding pause (pump must go to 1%) and...

status is unkown, that's ok. but not losing control!!

i reduce the flow to 10%. so far it looks good.
but what you say is that when the setup is bigger then the actual flow, the p3 loses control over the eheim.
that's not good

it now reads: normal auto off (and sometimes: normal)

matthias,

i installed 5.0.5.4, the status switches between normal and normal aut

Frank,
what do you need to know exactly?
i did sent you a couple of mails with information you asked..

what information did i forget?

thanks for you're post.
i had the idea that everyone at ghl were ignoring us

i guess it's already checked.
it has been reported for a couple of weeks now

cable between controller and pc, start update and then cable between controller and profilux

i simply use feeding pause, the eheim must go back to 1%. as set with plc
sometimes that works, but when display reads ***1, nothing happens

the filter keeps running, but will not respond to commands.

with the last version 1.03 the same problem! (***1, and no reaction of the filter)

quote: es scheint so, als wenn die komplette Abschaltung der Pumpe (0%) zu Problemen führt, der Betrieb zwischen 1%...100% hingegen läuft auf unserem Testfilter seit Wochen problemlos

maybe there...

just a restart of the p3 (power off/on) and the filter is running again
mode: permanent
wave: no waves
min 1% max 81% night 81%

that's all

the other problem still exists.
every now and then the filter stops working. only a green led running up and down.
the view2 display reads: eheim ***1
the eheim controller looks good, flashing...

no problem.
yes my problem is solved, i did sent you an email.

thanks!

mein deutch is nicht so good..
but i guess you're kidding? -> sorry dafür, aber bei uns hat anscheinend keiner versucht den Stecker so tief wie möglich reinzuschieben!

it's normal for an...

funny, i shutdown the eheim controller and.... 5 yellow/orange 1 green......
the eheimcontroller is off, because 2 a 3 times a day it stops working.

not only no data from the eheim filter (if i use the original cable with eheim control center it works fine)
but everyday my filter stops working, the filter is doing nothing and the green leds are...

here also no eheim data. i can control the eheim 2078 but no data
type unkown
status off
etc

how can i update the eheim controller?
there is as far as i know no "update eheim" button?
just found it, sorry

my profilux sent mail if there is a problem. i only get mail with: ALARM
can the profilux sent mail with the problem? ph to low or temp to low?

so i own a 4 dosing pomp on s1 - s4 digital with numbers 13 t/m 16. i can connect a second dosing pomp to the second connecter on the first dosingpomp with numbers 17 t/m 20
so 2 dosing pomps on...