I have just bought a P4 and I can not connect to the Hotspot the yellow LED comes on I go to add device> new configeration> connect to hotspot it gives a error "a connection problem has occurred...
Type: Posts; User: gino555
I have just bought a P4 and I can not connect to the Hotspot the yellow LED comes on I go to add device> new configeration> connect to hotspot it gives a error "a connection problem has occurred...
I am getting the above message, I have re calibrated the pumps and probe and still getting this message.
Please can you advise? If there is anything else I can do to resolve this problem?
any updates on this?
Thanks Vinny,
They are all on Channel 11
i have reset my mitras lights to factory settings after moving house I have tried to set my lights up and set the address's as slave 2&3 when I transmit my project it only transmit to one light only...
Does anyone know where to get decent dosing tube for the KHD?
I ordered some form my LFs and it don’t fit!
Any news on when this will be availbile for the P3?
Mine seemed to be ok for a while then I came home and the KH dropped to 7.6 I checked with a test kit and it should have been 8.2kh I then ran the reference solution on the KHD and it was reading -.6...
I checked my salifert test kit and it was reading .7kh high
might be worth getting a reference solution to check accuracy of the Hanna
Second test done with 7kh Ref solution
Result 6.4KH
1031610316
This still happens to me on occasions
I have had some fluctuating results on my KHD so dug out some reference solution set at 7dkh and thought I would test the how accurate the KHD, I did not have much faith in the KHD performing well...
i have worked out it is the cable,
is the rj12 cable crossed pins or straight through?
I have a doser gen 1 that has been in the cupboard for ages and I thought i would get it out and set it up, i cant remember the led set up should the comms LED be on all the time? as my dosser is not...
thanks
Any idea when the record measurement function will be available for the P3? as it will be a lot easier to see trends
I have noticed my readings on my KHD can fluctuate by 0.5kh,
What would cause this?
I have the test amount set to 100ml
would it be possible to add a diary function to myghl?
somewhere to input water test measurements and changes made to the tank would be handy.
Would it be possible to add a KH manual test button on the Profilux touch?
all my levels seem ok please have a look at my previous post photo
I cant work out what is the problem
Hi Vinny,
all my are above 60% except the waste water.
10201
1st test 10.5dKH
2nd test 10.5dKH
3rd test 8.7dKH
4th test 8.7dKH
5th test 8.8dKH
10195 10197101961019810199looks ok to me not sure if i am missing something
how do i check to see if they are running?
thanks for the reply.
all my doser levels are fine 10194
hi,
my doser and KH director logos are flashing yellow/blue,how do i find out what the warning is?