Search:

Type: Posts; User: Morlock

Search: Search took 0.00 seconds; generated 14 minute(s) ago.

  1. Replies
    2
    Views
    1,555

    ok Thank

    ok
    Thank
  2. Replies
    2
    Views
    1,555

    P3 Temperature probe

    Hello,

    I have had a P3 for a long time and I replaced it with a P4 because the LCD screen was no longer working and the temperature sensor started to show crazy values.
    Now I have bought a new...
  3. Thread: Powerbar2Dim

    by Morlock
    Replies
    3
    Views
    2,280

    Is there a manual or information on this powerbar...

    Is there a manual or information on this powerbar ?
    I can not find anything even on the official website...
  4. Thread: Powerbar2Dim

    by Morlock
    Replies
    3
    Views
    2,280

    Thank for your reply, i connected it to L1L2 now...

    Thank for your reply, i connected it to L1L2 now and the S1 led is red, what should I still set ?
    The profilux is running fine apparently.
    What is the clusters near the led on this powerbar ?
  5. Thread: Powerbar2Dim

    by Morlock
    Replies
    3
    Views
    2,280

    Powerbar2Dim

    Hello,

    I have a Powerbar2Dim-F/B, how connect it on profilux 3 ?
    I try to connect it to S1-S4 port on Profilux (i don't use S1-S4 and S5-S8) and configure the page "switch channels and outlets":...
  6. Thread: Min max level

    by Morlock
    Replies
    3
    Views
    1,856

    Thank you very much, it work fine I tested fill...

    Thank you very much, it work fine
    I tested fill water (ato) but with the numbers of the sensors not the number of level-control
    Thank :)
  7. Thread: Min max level

    by Morlock
    Replies
    3
    Views
    1,856

    no idea, nobody use it ?

    no idea, nobody use it ?
  8. Thread: Min max level

    by Morlock
    Replies
    3
    Views
    1,856

    Min max level

    Hello,

    I would use min/max level with 2 sensors (4 et 5 for me)
    what is the command corresponding with the action ?
    i test "water fill 4" and 5: not working
    i test "water fill (ato only) 4" and...
  9. Replies
    8
    Views
    15,142

    I view this: I try but i have an error to...

    I view this:



    I try but i have an error to erase flash:
    Error while transmitting firmware- FLASHERASE - no response - 8

    10239

    What can I do ?
  10. Replies
    8
    Views
    15,142

    Hello, I have the same problem I have a...

    Hello,

    I have the same problem
    I have a profilux3 Ex with 5.17 firmware...
    I must only use ProfiluxControl (firmware 5.0 to 5.17) to update the firmware (GCC not working) ?
    Have you a link to...
  11. Anybody help me ?

    Anybody help me ?
  12. WebInterface OK but LAN connection with PLC not OK

    Hi,

    I use a P3 Ex since 3 years and i am very happy.
    But i have a problem with my new office laptop (HP elitebook 8570W), impossible to connect my PL with PLC (LAN)&(WLAN)=> Error code 28
    I can...
Results 1 to 12 of 12