After talking with some guys about SVR1, it does not really do much for the number of LED's in my string. I took measurements with it turned all the way up and down and you can not see a difference....
Type: Posts; User: jdrabek
After talking with some guys about SVR1, it does not really do much for the number of LED's in my string. I took measurements with it turned all the way up and down and you can not see a difference....
The threads that I have seen most are driving the blues at 700mA and the whites at or near 1A. If you notice bleaching you can either de-rate the lamps even more or just adjust your dimming down.
...
Actually I meant to say .7 amps. I am not driving the blues at max current because of others recommendations.
Can anyone elaborate on the manual dimming in the controller for LED's? When in manual mode, which is based on %, my lights dont even come on until I hit 10%. Is this 10% of 1-10 volts or should I...
I new someone would have an image of it.
I just tested my first set of LED's using this board and a meanwell driver. My first one is blue only LED's, ran out of money, and the second one will...
The AC from the driver gets plugged into x102(ballast 1) or x103(ballast 2) depending on if you have 1 or 2 drivers you are using. Then you need to supply power to the board through connection x101...
the dimming lines from the meanwell, white(-) and blue(+), plug into x104 on the evg-ap2 and the power line from the meanwell plug into x103.
Did you get the instructions with the evg-ap2.
If...