ok
Thank
Type: Posts; User: Morlock
ok
Thank
Hello,
I have had a P3 for a long time and I replaced it with a P4 because the LCD screen was no longer working and the temperature sensor started to show crazy values.
Now I have bought a new...
Is there a manual or information on this powerbar ?
I can not find anything even on the official website...
Thank for your reply, i connected it to L1L2 now and the S1 led is red, what should I still set ?
The profilux is running fine apparently.
What is the clusters near the led on this powerbar ?
Hello,
I have a Powerbar2Dim-F/B, how connect it on profilux 3 ?
I try to connect it to S1-S4 port on Profilux (i don't use S1-S4 and S5-S8) and configure the page "switch channels and outlets":...
Thank you very much, it work fine
I tested fill water (ato) but with the numbers of the sensors not the number of level-control
Thank :)
no idea, nobody use it ?
Hello,
I would use min/max level with 2 sensors (4 et 5 for me)
what is the command corresponding with the action ?
i test "water fill 4" and 5: not working
i test "water fill (ato only) 4" and...
I view this:
I try but i have an error to erase flash:
Error while transmitting firmware- FLASHERASE - no response - 8
10239
What can I do ?
Hello,
I have the same problem
I have a profilux3 Ex with 5.17 firmware...
I must only use ProfiluxControl (firmware 5.0 to 5.17) to update the firmware (GCC not working) ?
Have you a link to...
Anybody help me ?
Hi,
I use a P3 Ex since 3 years and i am very happy.
But i have a problem with my new office laptop (HP elitebook 8570W), impossible to connect my PL with PLC (LAN)&(WLAN)=> Error code 28
I can...