Hi, i opened the housing, i couldn't see any loose cables, hope these photos will help.
Couldn't upload to the forum for some reason.
http://www.flickr.com/photos/78391959@N04/with/7182258678/
Type: Posts; User: Miike.
Hi, i opened the housing, i couldn't see any loose cables, hope these photos will help.
Couldn't upload to the forum for some reason.
http://www.flickr.com/photos/78391959@N04/with/7182258678/
My thoughts exactly but I was asked to do so, yes it's pushed in far enough. Tried it a few times.
I will be returning the probe, hope it's faulty not the controller
Hi, I've contacted the retailer. I've been asked to disconnect for 24 hours, keep the probe in water and then reconnect. I'll see if there's any change then look at the calibration.
Also the current...
Hi,
Thanks for the reply, just got in from work and had a good look, it all looks fine, no bent pins, the cable looks fine too, must be a broken cable under the insolation then I guess, a strange...
Hi,
I've set up a PIII and everything's ok except for the temp probe reading 38.7, it's in the bottom port, I've read this could be a connection issue, I've had it in/out a few times and a bit of...